KPC3+ Vers 8.3 to 9.1 Settings for Permanent AT use 2 Jun 2014 ---------------------------------------------------------------------- updated 3 Jul 2014 to put INT TERM in sequence and fix typos in LT original 2 Jun 2014 For permanent Golden Packet Sites we want the site to be visible, but not generate so many packets (15 digipeaters is quite a load) that we cut down on reliability. The calls are the mountain name and then the sequence number along the chain. With Georgia #1 and Maine #15. For Solar Powered stations, it is OK to have a photocell turning off the digipeater completely during darkness to save power. RESTORE the TNC to factory defaults using the RESTORE command MYCALL XXXXXX-X Where XXXXXX is your mountain name and X is number INTERFACE TERMINAL MYREMOTE ATCMD-X Where X is your station number MYNODE ATNODE-X NUMNODES 2 RTEXT goldenpacket FLOW OFF HEADERLN OFF BT not used BEACON 0 UNPROTO APN383 HID OFF CD SOFTWARE TXD 18 XMITLVL xxx <== adjust to well below distortion point (DEFAULT = 100) LT 1 !DDMM.hhNHDDDMM.hhW#PHGphgd AT: callsign [p = 6 for 25W, 7 for 50W LT 2 !DDMM.hhNHDDDMM.hhW#PHGphgd AT: callsign [h = 7 for 1280' HAAT LT 3 !DDMM.hhNHDDDMM.hhW#PHGphgd AT: callsign [g = 6 for 6 dBi gain LT 4 !DDMM.hhNHDDDMM.hhW#PHGphgd AT: callsign [d = 0 for omni BLT 1 EVERY 00:30:00 START 00:00:00 BLT 2 EVERY 00:30:00 START 00:10:00 BLT 3 EVERY 01:00:00 START 00:20:00 BLT 4 EVERY 02:00:00 START 00:50:00 LTP 1 APN383 LTP 2 APN383 LTP 3 APN383 via TEMP2-2 LTP 4 APN383 via HOP7-7 UIFLOOD HOP,30,ID UITRACE TEMP,30 UIDUPE 30 These settings assure a local (direct) beacon every 10 minutes and then a traceable one via TEMP2-2 via the two adjacent digis every hour and then a long shot HOP7-7 attempt once every 2 hours. The BTEXT is not used, since it cannot be synchronized with the other 4 LTexts to get the timing right. TE 60 can be used if battery telemetry is desired once an hour. de WB4APR, bob